E-Mu Pipeline Guía de usuario descargar pdf (Pagina 17)

14 Troubleshooting Wireless Features

• Reposition your transmitter or receiver so that there are fewer objects

(for example, multiple walls or large metal structures) between them.

• Make sure your transmitter and receiver are not placed on metal

surfaces.

• Reset the wireless connection. Press and hold the receiver’s Connect

button for five seconds.

• Disconnect the transmitter and receiver from the power source. Then

reconnect them again and reset the wireless connection.

• Check that you have set the Mode DIP switches correctly for your

transceivers. See “Configure your E-MU PIPEline™ units” on page 5.

I need more battery-powered transmit time from my E-MU

Pipeline™ transmitter.

If your battery-powered E-MU PIPEline™ transmitter is running low on

power, simply swap it with your receiver (assuming it is plugged in) and

reverse the R/T DIP switch on each unit. The pairing should remain intact.

I have two transceivers which are configured as transmitters. My

receiver is receiving the incorrect transmission.

Check that you have set the same RF setting for both units in a transmitter-

receiver pair. See “Configure your E-MU PIPEline™ units” on page 5.

EMU Pipeline UG.fm Page 14 Wednesday, March 4, 2009 5:56 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 72 73

Sin comentarios

E-Mu Pipeline Guía de usuario Pagina 17