E-Mu PROTEUS FX Manual de usuario Pagina 57
- Pagina / 134
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
4 - Preset Editor
Preset Globals
E-MU Systems 57
Channel Lag 1 & 2 Rate
Like the Layer Lag processors, the Channel Lag slows down rapid changes in the input
signal. The output “lags” behind the input at a pre-programmed rate.
Unlike the layer level lag processors, the Channel Lags 1 & 2 take effect as soon as the
preset is selected. In contrast, the Voice level lag processors begin acting only after a
keyboard key has been depressed. The Channel Lag also has a Lag Amount input which
controls the lag time. Positive lag amounts increase the lag time. A MIDI controller is
commonly used to control lag amount.
The Channel Lags could be used to slowly increase or decrease the speed of an LFO
which in turn controls some other effect, perhaps left/right panning, pitch, or the filter.
When a MIDI footswitch is used as the input, the lag acts to slow down the instanta-
neous change of the switch. The slowly changing output value can then be routed using
a patchcord to crossfade between voices or change the speed of an LFO.
Poly Key Timer
This processor starts a timer which begins counting down whenever a key is pressed
and stops when the key is released. The value of this timer can be used on any voices
assigned to the key after the key release. The Poly Key Timer is a special modulation
source controlled by the key and not the voice.
Poly Key Timer can be used to control the volume of a Release Layer in order to reduce
its volume the longer a key is held. This control is commonly used on grand piano
presets to lower the pedal damper volume the longer the keys are held.
Channel
Lag
Lag Amount
(+ value = longer)
ex. footswitch
Release
Layer
Voice
Poly Release
Trigger
Preset Global
Amp
Amp Vol
Poly Key
Timer
Note-On - Poly Key Timer begins counting down.
Note-Off - Poly Key Timer stops counting and outputs value.
Release layer
voice becomes
softer the
longer the key
is held.
- E-MU Systems 1 1
- Operation Manual 2
- Table of Contents 3
- 4 Proteus VX Operation Manual 4
- E-MU Systems 5 5
- 6 Proteus VX Operation Manual 6
- E-MU Systems 7 7
- 8 Proteus VX Operation Manual 8
- Introduction 9
- System Requirements 10
- Software Installation 10
- Setting up Cubase LE 11
- and Proteus XVSTi 11
- MIDI Channel 15
- On Your Own 16
- Proteus VX 16
- Main Window 16
- Troubleshooting Checklist 17
- Setting up the Preferences 18
- Audio Preferences 19
- Headroom/Boost 20
- VST Output Buses 20
- MIDI Inputs 21
- MIDI Response 21
- Controllers 22
- Other Settings 23
- E-MU Systems 25 25
- 2 - Guided Tours 27
- Multisetup Page 28
- Single View Close-up 29
- Channel 1-16 View 30
- Adjusting the Controllers 31
- Create Your Own Custom Bank 32
- Save and Save As 33
- Proteus VX Bank Structure 33
- The Librarian 34
- Find your Files 35
- Load your Files 35
- The Multisetup 37
- Saving your Multisetup 39
- The Output View 41
- Global Controls 42
- Proteus VX Aux Bus Routing 43
- Filter Descriptions 44
- E-MU Systems 45 45
- Preroll RAM Used 46
- CPU Meter 47
- Number of Samples Playing 47
- Current Channel 47
- Working with Multisetups 48
- E-MU Systems 49 49
- 4 - Preset Editor 51
- Preset Globals 52
- Capture MIDI Controllers 53
- TwistaLoop Lock To Tempo 53
- Initial Tempo 53
- Tuning Tables 54
- E-MU Systems 55 55
- Preset Modulators 56
- Templates 56
- Channel Lag 1 & 2 Rate 57
- Poly Key Timer 57
- Channel Ramp 58
- 5 - Effects 59
- Programming Effects 60
- Adding an Effect to a Preset 61
- FX Routing 63
- Effects Overhead 64
- Typical Effects Usage 64
- VSTi Bus Outputs 64
- Main Output Window 65
- Aux FX Screen 67
- Preset FX Screen 68
- E-MU Systems 69 69
- E-MU Systems 71 71
- Effects Listing 72
- Effects Descriptions 72
- Early Reflections Reverb 73
- Reverb Lite (mono) 74
- Background: Chorus 75
- Modulation Parameters 75
- Chorus / Delay 76
- Compressor 77
- Delay Mode: 79
- Discrete stereo 79
- Feedback 80
- Delay (BPM) 82
- (stereo) 88
- Pitch Shifter (mono) 89
- Ring Modulator 90
- Modulator 91
- TremFilter 92
- Tremulator Waveforms 93
- Drag & Drop 98
- Changing Settings 98
- Main Display View 100
- Tree View 100
- Refresh (F5) 101
- Context Sensitive Menus 101
- Undo/Redo 101
- View Menu 102
- 6 - Controls 102
- 7 - Synthesizer Basics 103
- Modulation 104
- Modulation Cords 105
- Envelope Generators 106
- Inverted Sawtooth 107
- Sawtooth 107
- Random Sources 108
- Clock Modulation 108
- Function Generators 109
- Modulation Destinations 110
- Modulation Processors 111
- Dynamic Filters 112
- Frequency 113
- Amplitude 113
- Parametric 115
- The Z-Plane Filter 116
- E-MU Systems 117 117
- Preferences 118
- Voice Edit 118
- MIDI Program Change Commands 119
- MIDI Modes 119
- 8 - Appendix 121
- Toolbar Functions 122
- MIDI Implementation Chart 123
- See note 126
- Received Channel Commands 127
- Special Notes: 127
- Controller Functions 128
- Numerics 129
- E-MU Systems 131 131
- E-MU Systems 133 133
Relacionado con productos y manuales para Instrumentos musicales E-Mu PROTEUS FX
Instrumentos musicales E-Mu B-3 Especificaciones
(196 paginas)
(196 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales