E-Mu PROTEUS FX Manual de usuario Pagina 65
- Pagina / 134
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
5 - Effects
Main Output Window
E-MU Systems 65
Main Output Window
The Main Output window is accessed by clicking the Outs button. (This option is not
available in “Single” mode.) This one window allows you to set the Host Application
Bus routing of the Main Output, enable the Preset Effects, and enable the Aux Outputs
for each MIDI channel. This window is extremely handy for turning all your effects on
or off.
The Preset Effect On/Off buttons are used to temporarily disable the selected A or B
effect while passing the signal. These controls allow you to hear each preset with or
without effects or to turn off all Preset Effects in order to gauge the CPU load incurred
by the Preset Effects.
The Aux Output On/Off buttons work differently than the Preset Effect On/Off
buttons and completely turn off the three Aux Sends for the selected channel. When
using the factory presets, the Aux Output buttons are used to enable or disable the Aux
Effects (because all outputs are connected to Bus 1. If you were using the Aux buses to
send signals to other Buses, the Aux button could be used to turn these outputs on or
off.
Output View
Selects the Main Output Window.
(Note: This button is disabled in “Single” mode.)
Aux 1-3 Select
Select between Aux 1, Aux 2, or Aux 3 FX in the TV view.
Preset Effects On/Off
Turns the Preset A or B effects On or Off for each MIDI
channel and passes the signal through.
Main Output Routing
Selects the Bus number for the Main Output. See tip -->
Aux Output On/Off
Turns the Aux Outputs On or Off for the selected channel.
This turns all three Aux Outputs Off, rather than bypassing
the effects. (Functions as an FX Bypass when the Proteus X
Composer bank is used. See page 66.
)
Aux1-3
Select
Preset
Effects
On/Off
Main Output
Window
Aux
Output
On/Off
Output
View
Main Output
Routing
The number of VSTi
buses must be defined in
the Proteus VX Preferences
before they appear in this
list.
- E-MU Systems 1 1
- Operation Manual 2
- Table of Contents 3
- 4 Proteus VX Operation Manual 4
- E-MU Systems 5 5
- 6 Proteus VX Operation Manual 6
- E-MU Systems 7 7
- 8 Proteus VX Operation Manual 8
- Introduction 9
- System Requirements 10
- Software Installation 10
- Setting up Cubase LE 11
- and Proteus XVSTi 11
- MIDI Channel 15
- On Your Own 16
- Proteus VX 16
- Main Window 16
- Troubleshooting Checklist 17
- Setting up the Preferences 18
- Audio Preferences 19
- Headroom/Boost 20
- VST Output Buses 20
- MIDI Inputs 21
- MIDI Response 21
- Controllers 22
- Other Settings 23
- E-MU Systems 25 25
- 2 - Guided Tours 27
- Multisetup Page 28
- Single View Close-up 29
- Channel 1-16 View 30
- Adjusting the Controllers 31
- Create Your Own Custom Bank 32
- Save and Save As 33
- Proteus VX Bank Structure 33
- The Librarian 34
- Find your Files 35
- Load your Files 35
- The Multisetup 37
- Saving your Multisetup 39
- The Output View 41
- Global Controls 42
- Proteus VX Aux Bus Routing 43
- Filter Descriptions 44
- E-MU Systems 45 45
- Preroll RAM Used 46
- CPU Meter 47
- Number of Samples Playing 47
- Current Channel 47
- Working with Multisetups 48
- E-MU Systems 49 49
- 4 - Preset Editor 51
- Preset Globals 52
- Capture MIDI Controllers 53
- TwistaLoop Lock To Tempo 53
- Initial Tempo 53
- Tuning Tables 54
- E-MU Systems 55 55
- Preset Modulators 56
- Templates 56
- Channel Lag 1 & 2 Rate 57
- Poly Key Timer 57
- Channel Ramp 58
- 5 - Effects 59
- Programming Effects 60
- Adding an Effect to a Preset 61
- FX Routing 63
- Effects Overhead 64
- Typical Effects Usage 64
- VSTi Bus Outputs 64
- Main Output Window 65
- Aux FX Screen 67
- Preset FX Screen 68
- E-MU Systems 69 69
- E-MU Systems 71 71
- Effects Listing 72
- Effects Descriptions 72
- Early Reflections Reverb 73
- Reverb Lite (mono) 74
- Background: Chorus 75
- Modulation Parameters 75
- Chorus / Delay 76
- Compressor 77
- Delay Mode: 79
- Discrete stereo 79
- Feedback 80
- Delay (BPM) 82
- (stereo) 88
- Pitch Shifter (mono) 89
- Ring Modulator 90
- Modulator 91
- TremFilter 92
- Tremulator Waveforms 93
- Drag & Drop 98
- Changing Settings 98
- Main Display View 100
- Tree View 100
- Refresh (F5) 101
- Context Sensitive Menus 101
- Undo/Redo 101
- View Menu 102
- 6 - Controls 102
- 7 - Synthesizer Basics 103
- Modulation 104
- Modulation Cords 105
- Envelope Generators 106
- Inverted Sawtooth 107
- Sawtooth 107
- Random Sources 108
- Clock Modulation 108
- Function Generators 109
- Modulation Destinations 110
- Modulation Processors 111
- Dynamic Filters 112
- Frequency 113
- Amplitude 113
- Parametric 115
- The Z-Plane Filter 116
- E-MU Systems 117 117
- Preferences 118
- Voice Edit 118
- MIDI Program Change Commands 119
- MIDI Modes 119
- 8 - Appendix 121
- Toolbar Functions 122
- MIDI Implementation Chart 123
- See note 126
- Received Channel Commands 127
- Special Notes: 127
- Controller Functions 128
- Numerics 129
- E-MU Systems 131 131
- E-MU Systems 133 133
Relacionado con productos y manuales para Instrumentos musicales E-Mu PROTEUS FX
Instrumentos musicales E-Mu B-3 Especificaciones
(196 paginas)
(196 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.104 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales